Sunday 6 June 2010

Building a kennel/table

After finding the idea on the internet I decide I was going to build a table, with a dog kennel enclosed underneath. Functional, pretty and the table can always be used as a stand-alone.

I used Sketchup and started designing the Table Kennel and a cutting list. One sheet of 18mm plywood was ordered (2440mm x 1220mm) and cut to size by the supplier.

Photobucket

I sanded all pieces and the four kennel sides were drilled to accept dowel bars.

Photobucket

At first, I was going to go with wooden dowels for the bars, then I found aluminium round tube which was slightly more expensive. Wood and metal gives a much better look.

Photobucket

No fancy jointing - I simply marked and drilled holes for 6mm wood dowel pins.

PhotobucketPhotobucketPhotobucket

Stained Mahogany Gripseal® gave the project a whole new look.

Photobucket

The table and the kennel. Two hinges and two sliding bolts ensure easy access.

PhotobucketPhotobucketPhotobucketPhotobucket

All in all, it could have turned out worse.

0 comments:

Post a Comment